What are the misunderstandings in installing Solar Powered Street Lights?
The
Solar LED Street Lights is a new type of energy-saving and environmentally friendly street light, which will not store garbage and will not affect the nature. Therefore, many urban lighting projects currently prefer to choose Solar LED Street. In addition, the installation of
Solar LED Lighting is much simpler and more convenient than traditional street lights. It is also true that some grassroots construction workers may take it wrongly during installation and make some mistakes that should not be made, which leads to the failure of street light solar led or lighting time very short. Today I summarized several misunderstandings about the installation of solar street lights. I hope everyone can avoid similar problems.
1. Freely extend the solar panel connection line
In some locations, because the installation of solar panels is too interference, they simply separate the solar panels and the lights a long distance, and some customers are separated by a distance of 10 meters or more, and then randomly buy two-core wires on the market to connect them. That's it. Since the quality of the general wires on the market is not very good, and the distance between the wires is very long, the wire loss is great, so the charging efficiency will be reduced a lot, and the lighting time will be affected.
2. The solar panel is placed indoors for charging
Some customers will install
solar lights in the parking shed to facilitate parking at night, but also install solar panels in the shed, so that the charging effect is naturally greatly reduced. In this case, we can use outdoor charging, indoor discharge, solar panels and lights. Install in a separate way.
3. With lights on both sides, the solar panels are tilted face to face
For the sake of beauty, the installer may install the solar panels face-to-face symmetrically, but if one side is oriented correctly, then the other side is definitely wrong. On the wrong side, the charging efficiency will be reduced because the light cannot directly reach the solar panel.
4. There are too many obstructions in the installation place, resulting in a decrease in the charging efficiency of the solar panel
For example, obstructions such as leaves and buildings block the light, which affects the absorption and utilization of light energy.
We will introduce more in next articles, thanks.
