Pay more attention to the waterproof and firm installation of the led lamp for outdoor lighting installation


In outdoor lighting LED projects, LED linear fixtures are a kind of lamps that are used more frequently. Sometimes LED linear lamps will be installed in more conspicuous places, which will affect the appearance if it is not done properly. At this time, how to achieve seamless connection is confused. Many people live, can this problem be solved?

When the led linear light is used for interior decoration, the installation is very simple. The back of the linear led light uses a strong 3M double-sided tape. When installing, you can directly tear off the sticker on the surface of the 3M double-sided tape, and then fix the linear led lighting where it needs to be installed. It’s fine to flatten it with your hands.

When the led linear lighting lamps of outdoor lighting engineering manufacturers are used for outdoor installation, they pay more attention to the waterproof and firm installation of the led lamps. This is mainly because the linear pendant lighting will withstand wind and rain. If 3M glue is used to fix it, the 3M adhesive will decrease over time and cause the linear fixtures to fall off, which will cause safety problems. Therefore, outdoor installation usually adopts card slot fixing method. The cut and connection place is the same as indoor installation, but it needs to be equipped with waterproof glue to consolidate the waterproof effect of the connection point, and then fix it with a special fixing clip. You can use an electric hammer. Drill holes or use plastic expansion tubes and screws to fix the clips.

The production process of outdoor lighting engineering lamps is very difficult. The width of the production line of LED linear lamp manufacturers is about 1 meter to 1.5 meters. This is a workbench set up for conventional standard products. If you need to produce one more than 2 meters From a production point of view, this will greatly increase the labor cost and the difficulty of production. Therefore, many linear light manufacturers are reluctant to customize led linear tube lights with a length of more than 2 meters.

Too long LED line lights will increase the risk factor of product loss during the transportation process. In the past transportation risk assessment, Crownda.LED knew that the longer the product length, the higher the damage rate, although it has been done before transportation. A series of packaging designs are used to protect it, but it is difficult to avoid the damage to the led product caused by the logistics after many circulations. At this time, there will definitely be customers asking: "The street lights are also very long, why can't the line lights be like streetlights? How about transporting like that?” It’s a good question. The street lamp is very long, but it is a long pole. The pole material is generally thickened steel or aluminum alloy, and the lamp body is thick and strong, without glass. The light body of the Linear Lighting in LED is thin, and the resistance to external force will become lower as the length increases.